Description Plate reverb is an artificial effect that utilizes a sheet of metal that vibrates sympathetically with a soundwave that hits it. The basic architecture of a plate reverb unit has a large, thin sheet of metal (nearly 6.5x3 in the case of the legendary EMT140) that has a transducer at one corner driving the sheet in much the same way as a speaker would, on the other end a pickup to capture the vibrations of the metal sheet, and a mechanical dampener that reduces the plate vibration. The reverb sonically stays out of the way of the dry path due to the minimal initial reflections and a full warm reverb that tapers smoothly fades out into a tail. In the studio, plate reverbs were routinely employed due to the way they added a natural ambience without interfering with the original program material - That and the fact that even though they were nearly 7 feet long and 4 feet tall, plate reverb units were a heck of a lot smaller than a giant room or hall when ambience was needed on recordings.Because plate reverb was born in the studio, on the Talisman we included studio style sidechain effects that are routinely paired with plates. These controls are PRE DELAY, which delays the reverb by about 100mS. And HIGH PASS, which rolls off the low frequencies of the reverb. Both of these controls allow you to tune the reverb, in order to keep it from interfering with the dry signal.
Product Features
- Era-defining plate reverb with studio-style controls.
- 479.99% smaller than the leading plate reverb.
Attributes
- Color (X): Gray
- Effect Type (X): Reverb/Delay/Echo
- Output (X): Mono
- Input (X): Mono
Included Items
[1x] Catalinbread Talisman Plate Reverb Effect Pedal Plate reverb is an artificial effect that utilizes a sheet of metal that vibrates sympathetically with a soundwave that hits it. The basic architecture of a plate reverb unit has a large, thin sheet of metal (nearly 6.5 x3 in the case of the legendary EMT140) that has a transducer at one corner driving the sheet in much the same way as a speaker would, on the other end a pickup to capture the vibrations of the metal sheet, and a mechanical dampener that reduces the plate vibration. The reverb sonically stays out of the way of the dry path due to the minimal initial reflections and a full warm reverb that tapers smoothly fades out into a tail. In the studio, plate reverbs were routinely employed due to the way they added a natural ambience without interfering with the original program material. That and the fact that even though they were nearly 7 feet long and 4 feet tall, plate reverb units were a heck of a lot smaller than a giant room or hall when ambience was needed on recordings.
Attributes
- Color (X): Silver
- Effect Type (X): Reverb/Delay/Echo
- Output (X): Mono
- Input (X): Mono
[2x] Hosa ING-100.5 6" Traditional-Style Jumper Cable The Hosa IRG1005 cable is designed to interconnect electric guitar pedal effects. Low-profile, right-angle plugs allow close spacing of pedal effects on pedalboards.
Attributes
- Type (X): Patch
- Color (X): Black
- Size (X): 6"